AUTOUTLET 2Pcs P6100 100MHz Universal Oscilloscope Probe,10:1 and 1:1 Switchable Oscilloscope Clip Probes with BNC to Minigrabber Test Lead Kit

These are of decent quality and are exactly what I was looking for. I needed a inexpensive pair of these for work. I didn't want to spend a lot of money but wanted something of fair quality. So far these have been more than adequate and didn't break the bank.

Good quality. Worked as it should.

I have an older Tektronix oscilloscope which needed new probes as the older ones were creating noise and I did not want to spend over a $100 bucks for a new Tektronics set so I deceded on this set. I have not had these probes very long but so far I am pleased with this set, as it turned out it is a great bargin at this price and it is a 1X/10X probe. Great flexibilty, strong clips for grabing the componet leads firmly and strong bond between the connectors and wire.

I'm kinda torn on this review. On one hand they are very questionable quality. On the other hand they were 15 bucks. On quality alone they are 3 stars. If you've used any kind of OEM probes, you'll know instantly these are cheap knockoffs. If you grade them on bang for the buck, it's clearly 5 stars. So I'll give them 4 stars despite the quality. I picked these because I had a function generator with no wiring either so I solved that problem for the same money and these arrived on time and the others I looked at wouldn't have. They did get me thru my time crunch but I'll be buying better and using these as backups. I hoped for better quality but for the price I can't complain. To my way of thinking, if you've invested any sort of money is a scope, spending 10-15 more bucks to get better quality seems reasonable. But if money is tight tight these do work. Just be careful with them.

I must admit, I wasn't expecting a lot, given the low cost, but I stand corrected. The probes came with the expected accessories, and trimming them to achieve children square wave reproduction was smooth, without glitching.

I used these to replace my 40-year-old Tektronix probes. They look and operate very similarly. See the attached picture for comparison. The tips work well, grab and make good contact. There is an x1 and x10 switch to attenuate the signal. They are solid and rugged enough to get a lot of use from them.

I am pleased with my purchase. After several years of use and abuse my stock 1054z clips were worn out and failing. These new leads did the trick. They seam fairly well built and accurate.

The tips on the prob are made of wider metal loop than most. They don’t have a lot of clamping pressure and do not grab small wires tightly enough to make a good connection. They do work adequately, but are not exceptional.

プローブの周波数補正用トリマーが収められている部分がシールドされていないので、この部分はノイズを受けやすい。ただし、よほど環境が悪くなければ問題なく使えます。 他社製の物ではプローブ先端の手に持つところあたりがノイズに弱かったので、安価なプローブは特性を理解して使えばよいと思います。

Great for general purpose oscilloscopes.

Wanted new probes for my overhauled Tek. Happy with them. Compensation works fine but dont forget to check the range for your scope. Cheap enough to carry a spare if they break. It seems all these Chinese probes are actually all made by the same factory - just the branding changes.

Wasn't expecting much at this price point, but was better than expected. Could only adjust compensation on one probe to the correct setting. The second one I could only get about 97% compensation.

I had a bit of an issue with one of the probes and the seller replaced that for me with ease. The probe works amazingly well and is made from decent material so I am happy :)