ACANII - For 2002-2005 Dodge Ram 1500 2500 3500 Black LED Tube Projector Headlights Assembly Headlamps Driver+Passenger

I like the style and quality. I installed LED lights in mine. You may have to fiddle with H1 LED for the highbeam to get it clocked correctly but it’s easily done To adjust the headlight. You have to remove them to get to the screws so they’re not like factory would be the only downfall.

Loved these headlights nice and bright, simple installation and gave the truck a clean look.

Changed out the bulbs to LEDs. DDM in low and Aukee in highs. The highs are better than a 50” light bar. Nice crisp spot beam easily reaches 1/2 mile. Lows are ok but not spectacular. Pain to adjust. Way better than OEM Don’t use HIDs. The low shut off when switching to high beam. Socwhwn you switch back HIDs take a few seconds to warm up. Projector lows have a decent line with minimal light scatter.

Stupid easy to install with t-taps for the LED lighting. Just wired them to the parking light constant so they are on whenever the parking lights or headlights are on. Could have wired to the ignition so that they were on all the time, but this was easy. Only issue I had was the parking lights use the stock bulb housing. I had aftermarket ones that wouldn't slot in. Quick and easy fix for great looking headlight assemblies.

I purchased a different model from the same company a few years ago and I had to modify the wiring for the low and high beam to match my factory wiring. This different model I had no issues and this new model the lights are a lot brighter. Well worth the money, especially if your head lights plastic is faded.

So first off as you can see in the first picture the mounting piece is blocking access to where the blinker light goes right where the wiring harness would clip into. On the second picture you can tell, if you look close enough, that the notches for the bulb are too small for it to even fit into it. For a $200+ product you would think there wouldnt be any issues with it but now i cant even put these on my truck after buying them, waiting for them and, wiring them up completely, to say I am dissatisfied would be an understatement.

These headlights look great, but they either need to redesign the lobe locations for the turn signals or provide adapters for their design. I had to purchase universal sockets, but they didn't even work! I ended up carving on the locking slots until the universal sockets fit. The instructions also talk about needing a CCFL power inverter. It would be better to create downloadable vehicle specific instructions, instead of sending a generic instruction book.

Had to use a dremel to.modify turn signal slot for bulble to lock in but nice product.