Bloem Easy Pour Watering Can, 2.6 Gallon, Black (20-47287CP)

This is a great watering can! The hole is a bit small and may require a bit of finagling if you have an odd faucet (such as our filtered water side faucet used for humidifier refilling). It is well balanced and has the second handle which rotates and "autoadjusts" based on how full the container is. It goes all the way through the can itself which was a smart way to go. THis way, no dinky pivot mechanism which would just break, or no cheap plastic-welds needed. Not quite the biggest watering can, but significantly bigger than most, plus it is pretty sleek. Note that the end does LEAK somewhat since there is no rubber on the joint between the can and the watering end. I recommend taking a microfiber or thin sponge or whatever and put on the bottom of it. Then duct tape and stick it to the watering-can side, and use duct tape to make a non-sticky circle ring on the endmost side. In other words, don't duct tape both ends to the can itself. This will absorb small leakage and allow you to still easily rotate the head as needed. The rainfall and pour options are extremely nice to have, using one for refilling humidifiers,etc, and the showerhead for plant watering.

I had some watering cans of the same capacity, but they were hard to carry when they were full because the center of gravity was off on them. They were also hard to fill because the handle was fixed directly over the filling hole. This one is VERY easy to fill due to the offset filling hole and VERY easy to carry due to the two handles. Also love the end of the spout. It has two ways to dispense the water: 1) fine droplets, like a rain shower; 2) a stream of water. The only drawback on this watering can is that the end of the spout pops off periodically. But, it is very easy to re-attach, so it is not a huge detraction.

i have always liked the quality of fiskars products, from their sewing tools to gardening tools. so when i needed to buy a watering can to use with the rainwater catch systems i installed, i zeroed in on this can right away. it looked nice from the photos, i couldn't find it in a local store. after reading all the negative reviews about drips from the point where the head attaches to the spout i was a little worried. i ordered it on amazon anyway just to give it a go, and the reviews were right - after attaching the head to the can and going out for a test drive, the can was dripping from the connection point every time i tilted it to pour out water. how annoying. i had the idea to try plumbers tape at the leak point though, so i removed the head, wrapped some of the tape around the spout, and reinstalled. no more leak!! now the can functions just the way i want it to. i mostly use the bigger opening since i am watering fruit trees, but found that the "shower" mode works best if i don't have the can filled all the way. the two handles are a huge help and make carrying the can around very easy, which i really appreciate since i am still healing from a hand injury. it's relatively cheap, pretty sturdy considering it's made from plastic, and with a little tape functions perfectly.

This is my 2nd purchase of this watering can. I have 2 sets of rain barrels, so one can is filling while watering with the other. I dump about 8-9 cans when watering the gardens and flowers. My first can is 2 years old, and still works as well as the new one. I really like how sturdy the body is, the large water capacity, the offset filling hole and the ability to rotate the head to pour water or sprinkle. The rotating handle seemed like a good idea, but I have removed it off of both cans. Here is what I can tell you after reading other reviews. Don’t use this in your house, and don’t use this on seedlings or delicate plants. The orange end cap can fall off if bumped with enough force. This has only happened 3-4 times, and it is easy to pop back on. There is a lot of water in this can, if you tilt it too fast you will get a lot of water. The water also does not immediately stop when you tilt it up, which is one reason you should not use it inside your house. The entire rotating head is pressed onto the can. It is not a perfect seal and water can drip at this connection. That is another reason to not use it inside your house. And for that one reviewer, you are correct, water spills out while carrying it if you over fill it. Might I suggest listening to classical music?

Quite large, and somewhat unruly. Holds a lot of water but is fairly heavy when filled. Water drenches plants regardless of which side of the spout you use. If you want to replace your arm day, water your plants/garden with this 2 in 1 dumbbell/h2o can.

There are a lot of things that I like about this watering can. I like the double handle. I like that the double handle swivels. I like the 2.6 gallon size - which is about 22 pounds. Not too heavy, but a decent amount to water plants. I like the dual spout too. But that is where things start to fall short. The end just snaps on, instead of screwing on. That means it isn't a real tight fit and it tends to come off unexpectedly. Also, the dual spout is a fabulous idea in theory, but doesn't really work well in practice. If the can is full, and the spout is in "shower" mode, you get a nice shower out of the bottom half, but if you tip farther, the shower get interrupted by the "pour" spout, and now you have just flattened your poor little plant. On the other hand, if you put it in "pour" mode, water still comes out of the shower part as well, so the water flow diameter is not limited like you would expect. Now your floor/patio, etc. is wet. Also, while I thought the color looked really cool...it is, in fact, quite HOT. That is, if you leave water in the can, it absorbs heat (especially in direct sunlight), and then you are watering your plants with 110 degree water. Ouch! Update: After using it for a couple of weeks, I have managed to destroy multiple plants as the spout is now falling off every time I use it. In addition, the swivel handle is a nice idea, but it needs to have some kind of stopper on it so it doesn't fall under the can. The picture shows both handles in an upright position on it own, but that is not reality. The swivel handle falls down as soon as you let go of it, and if you let go of that handle first, the swivel handle falls all the way down - UNDER the can. That means you can't set the can down on the ground until you physically grab that swivel handle again and pull it out from under the can. VERY annoying. At this point, I am totally done with this thing and I am sending it back.

Best watering can ever! It’s so easy to hold, the plastic is thick and very well made. Very very sturdy! I love the spout, both the showering 🚿 and with just a little twist on the end it changes to just one hole. Comes ready to go, all ya have to do is push the tip of the spout end on and the instructions on how to do it are perfectly said. It also holds quite a bit of water and when it’s full it is still easy to manage. This has made my life and my plants so much easier. I do not have any complaints. The video posted I made with just one hand lol, love this product so much.

I bought this product based on positive reviews I found when googling "best watering can" so I expected a sturdy and reliable item. There are two key features to this product that might raise it above what is otherwise a plastic jug for holding water: the rotating second handle and the spinning nozzle at the end that allows you to change from a sprinkle pour to a direct pour. The spout consists of the orange sprinkler head you see in the product description, the black cone shaped nozzle and an orange internal sleeve that fits it over the can spout. This unit was separated and zip tied to the can handle. The orange sprinkler head was broken as per the photo. The box is fully intact and undamaged so I don't know how it broke. But I would say it's a very flimsy piece of plastic and the point where it broke is a super weak spot given how think and brittle this material is. The piece, even broken, still snaps onto the spout head and seems to be strong enough to not pop off when I filled it with water and tried it out. I started to go through the process of sending it back which seems totally ridiculous for this piece of plastic which must cost less than a dime to produce. I just can't see going through all the time and expense, even if it is someone else's expense, to send this whole giant box back to where-ever and have a whole other unit packed in another box and flown over to me all for this tiny part. I didn't see where I could contact the seller so maybe they read this. I'll try to fix it with some epoxy putty or something. It's a bit disappointing because I like to research even small purchases like this and I expected among the best. I think the whole spout assembly could be a bit more sturdy and finished for not much additional work in general. Id be happy for just a replacement orange spout end but Im not gonna send the whole thing all round the world for it. It will pour water either way.

Cumple lo anunciado, ha sido satisfactorio su uso y apariencia el tiempo que tengo usándola (un par de meses).

Not sure what people are complaining about, as I've found this watering can to be quite useful. The head is pressed onto the can, and could fall off, but in my extensive use that has only happened once (human error). The second handle allows for better flow control from the spout. The plastic is strong and is able to hold a full tank easily. The off-centre hole makes filling a breeze. Like most things with gardening, care and consideration should be used; so don't go full-tilt (read: dump) the water out or you will disrupt your soil and stems/branches.

If you're not sure if you want to spend $100 on a watering vessel, keep in mind that this one will very likely be the last one you'll need. It's beautifully built, feels good in the hand, plenty of control and optional ways or pouring. A true pleasure to use.

Cumple con su función y la capacidad que tiene es ideal para regar las plantas de mi terraza con una sola carga.

Works great apart from the fact that when I have the nozzle set to the shower-mode, after I'm done it keeps dripping water for a minute or 2 after. Sometimes the nozzle likewise has a hard time getting a good seal and leaks as well while watering.