blue toggle switch 10pcs

Work great fit in small spaces

These are actually DPDT switches, just have only two wires connected to terminals so they are on/off configuration. Easy enough to add a third wire and use as on/off/on if your application requires it. The wire length has been more than enough for my applications - sort of hate cutting off extra; but the wire is very good quality so I save the cuttings for other projects.Overall I rate this as one of my better purchases. I've already used all 10 in projects so I will certainly look to buy these again. To date the switches have not had lots of use so durability isn't confirmed yet; but none have shown any signs of problems.The small red toggle covers are easy enough to slip off if you don't need them. They also will slip back on should you change your mind. The switch action is typical solid operation with little chance you will mistakenly activate one.Overall I'm very pleased with these switches and find them a great buy given they already come wired such that it simplifies my work!

I don't like to write reviews and I don't do many, but I am really impressed with the quality control on these switches. For the price it is an outstanding value. I have purchased and put into use 70 of these switches, without a single failure. They ALL have all the correct mounting nuts, star and rotational lock washers. The ALL have the same length wires. They ALL have heat shrink on the wire solder point. I made an assembly of them to use on a mockup for developing the program for a PLC. Because I was expecting that there would be a bad one here or there, I tested a couple before I made the assembly and wired it up and those I tested worked. So I decided to put the whole thing together and wire it up and then change out any that were a problem. Out of 70 switches, THERE WERE NO PROBLEMS! I am impressed and I would recommend these.

Good switches, good price and quality

I purchased about one hundred and twenty of these switches for a school-aged STEM project for the Bring Your Child to Work day at my place of employment. We used these switches to control a motor powered by a 1.5 volt battery at less than one amp. The switches were pre-wired with leads and the soldered connections were covered with heat-shrink tubing. These switches were a good value for the money. We only had one switch that was defective out of the 120 purchased.

these are amazing for small projects to hide the switch but they will break if your to aggressive, also when you bolt on from the back you have to do it super lightly when its a little hard then STOP if not you will tare apart the internals and the switch won't work, I used for gokart lights and I have not switched since, Ive had them for over 6 months no problems

Perfect size and the wire leads are nice and long. Just what I needed.

Very disappointing to have so many duds since they wasted so much of our time. But I do like those that worked, and so far they haven't failed after a successful installation.